I'm trying to replace the coolant temp sensor (temp gauge sensor - black connector) in my van. By that I mean reinstall the original sensor which popped out when I inadvertently removed the clip. I pushed the unit back in the hole and reinstalled the clip but then I noticed it had a lot of wiggle and I was easily able to pull it out. What is going on here? Looking at the unit I see no groove for the clip to catch on to. Either I am missing some part that fell off or I am doing something wrong. The only thing I can think of is the o-ring must not be pushed all the way back and the clip holds between the unit and the o-ring. But I don't see how this would prevent the unit coming off? The other possibility is the coolant temp sensor and temp II sensor clips are not interchangeable and I got them mixed up (they looked the same to me). I hope someone can answer soon as I wanted to get this done this morning and refill the coolant before it hits 100 degrees here in AZ.
David (1987 Wolfsbug, currently coolant-less)
________________________________ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.