Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2013, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 20 Sep 2013 09:28:37 -0400
Reply-To:     Ed McLean <email99@BELLSOUTH.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Ed McLean <email99@BELLSOUTH.NET>
Subject:      Re: Front-end workout

If you are going to take the time to rebuild the front suspension, you might as well add grease fittings to the ball joints and tie rod ends. It's cheap, easy, and straight forward to do if you have the suspension apart. Since the replacement parts seem to have a shorter life than the originals an annual squirt of grease is something that won't hurt and might help in extending their life. Grease fittings can be installed on everything except the inner control arm bushings.

Grease fittings can be installed without disassembling the suspension but it is much more difficult.

Ed


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.