Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2013, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 23 Sep 2013 14:22:27 -0700
Reply-To:     Old Volks Home <oldvolkshome@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Old Volks Home <oldvolkshome@GMAIL.COM>
Subject:      Re: Wiring harness to distributor plug
Comments: To: Paul Rogers <wognacious@gmail.com>
In-Reply-To:  <2D83EBE3-989F-4BBB-8AE7-1FEC325CF490@gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

The 3 pin plastic connector on the harness is VW 211 905 327, Dealer still available $6.70ea (Approximate)

The Boot for the plastic connector is 281 919 141 A, Dealer in North America NLA $5.09ea when it was available

For the sake of convenience, I buy them all the time at VW, but is usually not a stocked item.

To repair the wires I usually get the metal connectors with about a 3 inch white pigtail attached from VW (again as a matter of convenience) - VW 000 979 133 E $8.20ea (Approximate), solder them and insulate with heat-shrink tubing. I've done this on several Vanagon Wassers. Unfortunately none of my Bosch WD suppliers carry the connector.

Jim Thompson 84 GL 1.9 "Gloria" 84 Westfalia 2.1 "Ole Putt" 72 411 Station Wagon "Pug" 75 914 1.8 "Nancy" Full Timing From March 1999 To January 2012 oldvolkshome@gmail.com http://www.oldvolkshome.com Find me on Facebook: http://www.facebook.com/people/Jim-Thompson/100000710343835 ***********************************

On Mon, Sep 23, 2013 at 5:34 AM, Paul Rogers <wognacious@gmail.com> wrote:

> Hey Ken, I have an 85 Weekender that I just put a 2.1L long block in with > all the parts from my old 1.9L. I just got it running last week and was in > the process of dialing in the idle and timing when this happened. I'm not > positive but it might be VW part #052 905 327. But now I found ths too. > Thanx, > Paul > > Home » EFI Hardware Products » Electronics » TPS Sensors Kits and Parts » > connector TPS 3 pin plug Bosch > connector TPS 3 pin plug Bosch > Bosch Equivalent Part Number: 1 237 000 039 > Plug to suit Bosch 3 pin TPS. Also suits Bosch 3 pin igniter modules and 3 > pin air regulators. > > > > > Enlarge Image > Product Code:H-TPSBC > > > > AUD $10.00 (ex GST) > > > Bulk Pricing > 1+ $10.00 > 5+ $7.50 > 10+ $6.00 > 25+ $5.00 > > Product Details > Equivalent Bosch Part Number: 1 237 000 039 > > Sent from my iPad > > > On Sep 23, 2013, at 4:47 AM, "kenneth wilford (Van-Again)" < > kenwilfy@comcast.net> wrote: > > > > Paul, I should have this connector new. It is for an 86 or newer > Vanagon correct? > > > > Ken Wilford > > John 3:16 > > www.vanagain.com > > > > > > > >> On Mon, Sep 23, 2013 at 2:40 AM, Paul Rogers <wognacious@gmail.com> > wrote: > >> Hi List, > >> Does anyone know a source for this part, Bosch 1 234 485 024 Plug > Sleeve, Ignition System. It's the connection from the coil to the > distributor. The wires in my plug were kinda stiff/hard and of course I was > fiddling with the connection and broke off a couple of wires. The > brown/white and the red/black to be specific. I found a source over the > pond but I'd prefer to buy here. Or any other alternative fix info would be > nice too. > >> Thx and good nite, > >> Paul in Tracy > >> > >> Sent from my iPad > > > > > > > > -- > > Thanks, > > Ken Wilford > > John 3:16 > > www.vanagain.com >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.