I found one head a real bear to remove. I got it off with a pry bar ( you see the tabs on the cylinders where to can pry). But not just any pry bar works. I ground the tip of the pry bar to a sharp edged 90 degree end. Then the tip would hold on to cylinder tab. Alistair
> On Oct 6, 2013, at 12:17 PM, Tom Carchrae <tom@CARCHRAE.NET> wrote: > > My head removal is going ok so far. (84 1.9L) I have spent relatively > little time on it so far, but am keen to get the job finished before too > long. > > Only minor exhaust wrestling - one broken stud (although with an ample > amount |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.