So I put heads on an engine. The lifters seem firm, pushrods are straight.
Now what? Set to tdc #1 and adjust valves in just until contacting? Then turn main pulley 90* and repeat I cylinder 4? What's the trick to keepin the pushrods in the center of the lifter while getting them onto the rocker assembly? Thanks!! -craig |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.