On Sun, Oct 6, 2013 at 3:08 PM, Alistair Bell <albell@shaw.ca> wrote: > > I found one head a real bear to remove. I got it off with a pry bar ( you > see the tabs on the cylinders where to can pry). But not just any pry bar > works. I ground the tip of the pry bar to a sharp edged 90 degree end. Then > the tip would hold on to cylinder tab. > Yeah, I've picked through all my tools so far and none fit well - tiny wrenches being the only fit, but they are strong enough. Perhaps something like http://images3.wikia.nocookie.net/__cb20130504052308/shipoffools/images/5/59/Excalibur.jpeg Tom |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.