To reinstall my headlight I finally found some connectors that would work (3M ones from Walmart were useless) at Harbor Freight Tools. These are the kind that the wires slip in at each end you crimp them on and then heat-shrink the covering. Well all went well till the last step. Exactly how much heat do these require and for how long? (no mention on package). I used my daughters hair-dryer on the highest heat setting about one inch away for 5 minutes until I could smell burning. The center part shrank but the ends, where the shrinkage is really needed did not shrink at all. So both ends are now open to moisture. Anyone have a clue? This replacement of the 9004 socket is turning into a major project.
________________________________ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.