Date: Tue, 1 Oct 2013 11:01:33 -0700
Reply-To: Scott Daniel <scottdaniel@TURBOVANS.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Scott Daniel <scottdaniel@TURBOVANS.COM>
Organization: Cosmic Reminders
Subject: Re: Hall Sender- 2.1L engine.
In-Reply-To: <CAN5Ep7TeQKj+0OfrYxzCo_peMcqA+vxrmJJ=P7K5gL4svfY3iA@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
I've done a 1.9 one and a 2.1 one.
for one thing ..take the dist out of the engine !
It's one screw to loosen, and it can't go back in incorrectly if you
half pay attention.
Note the rotational position so the timing is close to where it was.
the main important difference between the two types is the plug on the
side . They are slightly different.
what I remember is ..
for a 2.1 the whole thing needs to come apart ...the whole shaftn'
everything.
on a 1.9 ..ithall sender canjust be removed and swapped from the top.
Bentley tells about the 2.1 if I remember correctly.
On 10/1/2013 7:33 AM, Zeitgeist wrote:
> It's been many moons now, but I remember needing to completely disassemble
> the entire distributor when I swapped in a Hall sender from a Volvo 740,
> due to the fact that my external plastic connector was broken off, causing
> intermittent running issues. I pressed out the roll pin in the base of the
> drive and pulled the whole shaft in order to remove the assembly. Perhaps
> I overcomplicated things, but that's what I did. Near as I can tell, most
> four cylinder Bosch Hall units from that era will drop right in
>
>
> On Tue, Oct 1, 2013 at 6:17 AM, Steven Shelton <shelton4@gmail.com> wrote:
>
>> I did a write up when I replaced the Hall on my 1985 1.9L here:
>>
>> http://www.thesamba.com/vw/forum/viewtopic.php?t=524320&highlight=
>>
>> I don't know what the difference would be for a 2.1 but it is a different
>> part number. On the post, Windnsea replied that I did not have to remove
>> the distributor to replace the Hall, but did not provide any details. Even
>> if it were possible, with so many tiny screws that have to be removed I'd
>> surely drop at least one in an inaccessible place.
>>
>>
>> On Tue, Oct 1, 2013 at 8:06 AM, Jim Felder <jim.felder@gmail.com> wrote:
>>
>>> John,
>>>
>>> If I recall, pop the distributor cap, remove the rotor and plate and lift
>>> the sensor out of its slot. Unplug the other end and plug the new one in
>>> like that one came out. There may be a little more to it than that but
>> not
>>> much.
>>>
>>> Jim
>>>
>>>
>>> On Tue, Oct 1, 2013 at 6:04 AM, JRodgers <jrodgers113@gmail.com> wrote:
>>>
>>>> How difficult is it to change out the hall sending unit. Mine is shot,
>>>> apparently. What has to be done?
>>>>
>>>> Thanks,
>>>>
>>>> John
>>>>
>
>
> --
> Casey
>
|