Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2013, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 15 Oct 2013 17:50:30 -0500
Reply-To:   ralph meyermann <ralphmeyermann@GMAIL.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   ralph meyermann <ralphmeyermann@GMAIL.COM>
Subject:   Re: cv joint question
Comments:   To: Jim Felder <jim.felder@gmail.com>
In-Reply-To:   <CAFnDXk2T_ceF7MryES44r_nXP0dYuOTViWQ1UEjnk7Jo+XwfyQ@mail.gmail.com>
Content-Type:   text/plain; charset=ISO-8859-1

Thanks, but what about the cone washer and the shoulder on the splined inner? Should it be placed inside or outside on the shaft?

Velma 82 1.9L AAZ td westy On Oct 15, 2013 5:39 PM, "Jim Felder" <jim.felder@gmail.com> wrote:

> I have Bus Depot boots on my van right now, and they seem pretty good. Time > will tell. This after a horrible three-year spell of getting crappy boots > locally. My point is, the quality varies. If I had a good set of OEM VW > boots on my vanagon I would leave them alone if they were not split before > I would put some iffy aftermarket brand on. Been there, done that, once > every ten months or so. > > The good ones seem three times as thick and much more pliable than the bad > ones. > > Jim > > > On Tue, Oct 15, 2013 at 5:34 PM, Michael <mbucchino@charter.net> wrote: > > > Inspect them closely for good long term usage. If they pass your > > inspection for defects or aging, go ahead and reuse them. Just realize > > what a pain it can be to have replace them later if they go bad. > > > > Mike B. > > > > Sent from my iPhone > > > > > On Oct 15, 2013, at 17:54, ralph meyermann <ralphmeyermann@GMAIL.COM> > > wrote: > > > > > > Hi all! me again bugging the biggest collective of Vanagon knowledge > for > > > help. I finally removed one side to replace the cv joints and noticed a > > > difference between the old and the new lobro ones. The new ones seem to > > > have a small shoulder on one side and the old ones do not, and the old > > ones > > > seem not to have the cone shaped washer provided in the new kits? Also > if > > > my boots arent torn should I reuse them? Thanks as always > > > -- > > > Velma 1982 1.9L AAZ turbo diesel Westy > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.