Date: Tue, 22 Oct 2013 13:56:07 -0700
Reply-To: Scott Daniel <scottdaniel@TURBOVANS.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Scott Daniel <scottdaniel@TURBOVANS.COM>
Organization: Cosmic Reminders
Subject: Re: Noisy transaxle??
In-Reply-To: <5266918E.5080601@cox.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
re 'the input/pilot shaft turns at
the same speed as the crank/flywheel."
yes, this is true of the Pilot Brg in the end of the chankshaft/flywheel.
Once in gear ...that bearing is not turning.
however...the input shaft bearing on the transmission input shaft is
always turning , unless the clutch is held in, van not moving.
Idling in neutral ..
or driving down the road ..
the input shaft bearing just inward from the bell housing is turning ..
it is also driving, by a gear, full time ..the Pinion Shaft assembly and
bearing/s there.
also .....the poster who changed just the input shaft bearing by
removing the bell housing and using what I call a 'blind hole bearing
puller'
( that's like a tool with narrow fingers that will reach down over a shaft..
and grab the bearing cage and rollers and pull it out ) ..
if that helps the transmission ...fine.......buys you some time.
And, by the time any bearing starts failing..
it's not like all the other bearings are just fine. especially.
also ....the metal that gets into the gear oil ..from syncronizers
where, and bearings wearing ..
that metal in turn increases wear ..
which is why gear oil needs to be changed. Just left to wear ...it
starts to harm itself ...
from the normal-wear, and normally occurring metal particles doing more
damage.
Scott
On 10/22/2013 7:54 AM, mark drillock wrote:
> When your foot is OFF the clutch pedal, the input/pilot shaft turns at
> the same speed as the crank/flywheel. Thus the bearing in between them
> is not being asked to do anything at that time. Since you said it makes
> the noise when your foot is off the pedal it shouldn't be this bearing.
> You have an internal tranny bearing going out. The 091 tranny can make
> bearing noises for a long time and still work. On the other hand it
> could fail suddenly at any time. I have experienced both with my AAZ
> powered vans.
>
> Mark
>
> ralph meyermann wrote:
>> It seems like just a bit more noise than an input shaft bearing should
>> make, if I raise the rpm and the engine drowns it out? I think there are
>> more issues that need attention inside the transaxle.
>>
>> Velma 82 1.9L AAZ td westy
>> On Oct 22, 2013 7:53 AM, "Larry Alofs" <lalofs@gmail.com> wrote:
>>
>> I push in the clutch and
>>>> keep
>>>>>> the
>>>>>>> engine rpm there is a big noise reduction? There is also some
>>>>>>> noise I
>>>>>> hear
>>>>>>> Idling in neutral that goes away when I push in the clutch (New
>>>>>>> throw
>>>>>> out
>>>>>>> and pilot bearings).Are Vanagon 4 speeds noisy? I have yet to ride
>>>> in a
>>>>>>> Vanagon other than my own to compare with, I believe I need that to
>>>> know
>>>>>>> for sure.
>>>>>>> Velma 82 1.9L AAZ td westy
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>
>>>>>
>>>>>
>>>>
>>>
>>>
>>
>
|