Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2013, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 7 Nov 2013 16:03:25 -0800
Reply-To:     Tom Carchrae <tom@CARCHRAE.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tom Carchrae <tom@CARCHRAE.NET>
Subject:      Re: Coolant Pipe repair
Comments: To: John Goubeaux <john@ucsb.edu>
In-Reply-To:  <527C24AB.4080104@ucsb.edu>
Content-Type: text/plain; charset=ISO-8859-1

Keep in mind that is going to be 10-15 PSI of pressure - so not a great spot for a band-aid. If you do try and patch it, perhaps an extra wide hoseclamp over the patched area - very carefully tightened so as to be snug, but not crack the plastic... but sounds to me like you need to fix those pipes properly.

On Thu, Nov 7, 2013 at 3:39 PM, John Goubeaux <john@ucsb.edu> wrote:

> 90 2.1L > > Does anyone have any advice on coolant pipe repairs ? > > I was about to change out the two large hoses that feed the radiator and > noticed that where the return hose clamps to the return straight pipe > there appears to be a small crack that is allowing the coolant to weep > past the clamp. I was hoping to not replace the pipes just yet but > realize the plastic gets brittle and will fail SO thinking that with > maybe epoxy and or fiberglass the end could be repaired ? Not sure what > will adhere to the plastic ? Are the original ones made of PVC ? > > -john >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.