Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2013, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 7 Nov 2013 05:50:07 -0800
Reply-To:     Stephen Grisanti <bike2vcu@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stephen Grisanti <bike2vcu@YAHOO.COM>
Subject:      Re: Seat Options
Comments: To: Scott Daniel <scottdaniel@TURBOVANS.COM>
In-Reply-To:  <527B0FD4.8010107@turbovans.com>
Content-Type: text/plain; charset=iso-8859-1

Early Eurovan seats ('93 to about '97) can be fitted by trimming off the downturned edges of the seat rails to fit into the Vanagon seat tracks.  This is what I did.  Later Eurovan seats have a different rails so might be more involved to make fit.  Non-Westy Vanagon seats will slide right in.  Both will have thicker seat bases than a Westy seat so when installed on the swivels will lift your seating position relative to the stock seat.  Some folks do not like this.  If you are long-legged your knees may be closer to the dash than you like.   I expect the Vanagon seats would be easier for you to find, but I happened to find EV seats first so that is what I used.  Vast improvement over stock in my '87 Westy, but I also had to further modify the seat rails, notching them at the back in order to slide the EV seat farther back to get the leg room I wanted.   Several threads on the Samba about different seats. Lots of helpful and informative pix.  One guy added Ford Econoline captain's seats to his Vanagon. Good luck!   Stephen On Wednesday, November 6, 2013 10:56 PM, Scott Daniel <scottdaniel@TURBOVANS.COM> wrote: Eurovan seats can be adapted without too much trouble and are pretty nice.  Easy to fine the details online. you could also get seats from an 86 and later Westy ...those might be a little more plush. Be aware that non-westy seats are thicker on the bottom portion than your Westy seats that are on swivels are. Since the driver's swivel is never used .. I like to remove it, then keep the same seat and have more head room .. OR use a non-westy seat that's thicker on the bottom and will keep you at about the same eyeball altitude that you have with your current driver's seat. you can get some fine Recarro's for up to $ 1,500 each, new,  I believe. On 11/6/2013 5:22 PM, Kevin Gilbert wrote: > Volks, > > I'm interested in learning what front seat options may be out there for my '84 Westfalia. The originals are in decent shape, but maybe my backside would appreciate an upgrade. Easy fit and low cost, of course. > > My first van, a '66 Econoline, went through 3 seat configs: original vinyl low-back, a pair of jerry-rigged maroon velvet Shriner bus seats, and then a set of same-era Mustang bucket seats - suhweeeet. The Mustang seats slid onto the same tracks without alteration. > > Thanks. > > Kevin


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.