RE: Reference and Conversion Chart Thanks for the effort on this. I still have the two charts that hung above my fathers lathe for 40+ years, now probably 70-80 years old. Fraction size, decimal conversions on one. And the other for common threads, drill number size for tap or clearance. And number drill size to fraction. But no metric 'stuff'. When these were printed metric was only used by the enemy! |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.