Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2013, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 14 Nov 2013 21:36:47 -0500
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: '88 GL intermittent ignition miss
Comments: To: Gregory Smith <gfs@GREGORYFSMITH.COM>
In-Reply-To:  <20131114192053.ba2d9648c4914d5f56715942772a6035.abe305e48d.wbe@email02.secureserver.net>
Content-Type: text/plain; charset="UTF-8"

Look for loose wires, bad connections or most likely a bad sensor in the distributor. A broken connector on the dizzy can also cause the wires inside to get damaged. A bad ECU can also cause similar symptoms. The tach dipping/jumping indicates the problem is on the low voltage side so all those tune up parts were not needed. Vanagon syndrome has nothing to do with ignition. The airflow meter doesn't either.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Gregory Smith Sent: Thursday, November 14, 2013 9:21 PM To: vanagon@GERRY.VANAGON.COM Subject: '88 GL intermittent ignition miss

Heeeeeeeeelp!

I am pulling my hair out trying to solve an ignition miss on my '88 GL. When it happens, the engine is warmed up and I'm usually just cruising along. The engine stutters and the tach dips and even goes up a bit sometimes. The fuel pump is good, quiet, filter is about 2 months old.

Initially I suspected it needed and tune up and have replaced the plugs, cap, rotor, and wires using the appropriate parts from Bosch. The problem persisted so I replaced the ignition switch with a new one.

The problem persisted... reading up on the symptoms I thought it might be "vanagon syndrome" so I swapped in a different AFM, still there. Added the proper capacitor to the AFM innards, still there. Unplugged the O2 sensor... still there.

Any ideas? Does the hall sender in the distributor do this when it's failing? I think it's more of an on/off failure so I'm stumped. Thanks in advance.

Gregory Smith '88 Vanagon GL '77 Lancia Scorpion Olympia, WA


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.