Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2013, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 21 Nov 2013 10:15:32 -0500
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: High beams not working-lighting upgrades!
Comments: To: Bret Berger <bretberger@GMAIL.COM>
In-Reply-To:  <528DAB74.9060201@gmail.com>
Content-Type: text/plain; charset="us-ascii"

From the factory the 90 amp alternator was already an upgrade to support AC and the larger radiator fans that went with it. It is plenty sufficient until crazy loads are added. As for over current protection there are things to consider including avoiding nuisance disconnects, especially lighting, ignition, and fuel delivery. The Europeans use a separate fuse for head filament and the rear is split left-right. The Americans use a self-resetting breaker for the headlights so you get the lights flashing in case of an overload. Fuse links are also an option for the larger wires.

How much re-engineering do we want to do? What is there has worked for 22+ years.

A consideration for increasing the alternator capacity is "driving" it. The single belt can only transmit so much power and with the limited wrap around the drive pulley makes things worse. Even 120 amp alternators make for very short belt life. BTDT.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Bret Berger Sent: Thursday, November 21, 2013 1:43 AM To: vanagon@GERRY.VANAGON.COM Subject: Re: High beams not working-lighting upgrades!

Sounds like a good reason to install a properly sized fuse inline with a wire gauge upgrade. Perhaps an alternator upgrade would also be in order? Any voltage drop across your headlight/radiator fan/blower motor supply wire implies waste heat being dumped from the wire. Power = current x voltage. A 2 volt drop in a supply wire with a 20 amp load is 40 Watts wasted.

On 11/17/2013 6:35 PM, Dennis Haynes wrote: > Most auto equipment will work over a large voltage range but > performance does suffer. However it is not by accident or even cost > savings that the wiring is "undersized". As the system gets loaded > down thee resistances help to control the load on the alternator. > Also, as so much wiring is not over current protected the smaller > sizes also help to limit or control fault currents. Yes those wires > can act as fuses hopefully burning up enough to open before the van is gone.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.