At 03:47 PM 12/7/2013, Steve Cotsford wrote: >Hi Neil. I did a little more checking. It seems that each FI >plug does have a constant B+ on one side. For me it was showing >11.75 Volts As I was doing this testing with the pump relay in >place, I noticed that the B+ was only present when the pump was >running and when it disappeared and the pump turned off, this is >when the injector sprayed. I'm having trouble following this part. Your injectors should fire independently of the pump running; they're separate activities. The pump only runs during the period that the ECU is receiving pulses from the distributor (and I'm guessing for a second or two after) as a safety measure so as not to continue pumping fuel after an accident or fuel-hose rupture. The injectors OTOH fire on each individual pulse from the distributor. Of course if there is no fuel pressure nothing comes out (which is why the fuel pump runs for a couple seconds when you turn on the ignition key, to make sure that the fuel ring is up to pressure), but the injectors fire regardless. You can easily detect the actual mechanical action of the injector by using a stethoscope (Lisle is a good brand; the one they sell at Pep Boys with a joint in the probe is useless**), or a long metal rod/screwdriver pressed against your ear. The injector makes a very distinct click. **A good stethoscope will produce painfully loud sounds if you tap the end on something or drag it lightly across concrete. > I'm not sure what that means and I will have to do some more > reading but as the signal seemed identical at all 4 plugs, I'm > pretty sure it means that the 3 injectors that are not spraying are > doing so because of a fault within them each. Steve With the system ready but idle you should have B+ on *both* sides of the injector plug. If you don't then there's bad contact at the plug (or an open injector coil, of course). When it runs one side pulses down toward ground for the duration of the injector opening. If your Fluke can measure duty cycle you can see that happening. All the injectors are switched by the same transistor, so if you're getting pulses on some lines and not others it's a wiring issue. Yrs, d |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.