Thanks. This effort was just to separate the connector from the sensor - not remove the sensor itself. John
On 12/29/2013 8:26 PM, OlRivrRat wrote: > JR > > Assuming this pertains to your 88GL2.1L ~ You Push or SqueezeDown > (if you have it ConvenientlyOriented) on the WireClip & then if it > TheConnector does not want to come off easily you will probably need to > push a ScrewDriverBlade between TheConnector & TheSensor & then give the > ScrewDriver a GentleTwist ~ To remove the Sensor you Pull the > RetainingClip completely out & then Pull the Sensor out ~ Coolant > Will/Should Flow ~ > > ORR ~ DeanB > > > On 29 Dec , 2013, at 11:38 AM, JRodgers wrote: > >> I need to release the Temp II sensor. >> >> Question: Does one push the release clip - or pull the release clip - to >> unlock and free the connector. >> >> Having a problem getting it loose and it's hard to see the action from >> on top. >> >> Getting underneath to look isn't an option for the time being. It's been >> raining and water is running under the van. >> >> Thanks, >> >> John > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.