Thanks Mark. I don't understand the temp II issue. For what purpose would it be unplugged if it runs crappy at idle when trying to set the timing with the light? I learn something new about these beasties everytime theres a problem and have to find a fix! Thanks again. John On 12/29/2013 6:21 PM, mark drillock wrote: > Just set the timing at idle without unplugging the Temp II. I should > have said that I guess. > > That should get you close enough for it to run alright unless something > else is wrong. > > Mark > > JRodgers wrote: >> Mark, thanks. >> >> Bentley says warm up, disconnect Temp II, rev to 2000/2500, set timing. >> I needed the tach to do that. And it won't stay running long enough >> under those conditions to get the timing adjusted. Can't get any rpm out >> of it with the Temp II disconnected. Clearly - I must be approaching >> this wrong or misinterpreting something. >> >> > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.