Date:         Sun, 29 Dec 2013 22:24:41 -0700
Reply-To:     Karl Wolz <wolzphoto@Q.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Wolz <wolzphoto@Q.COM>
Subject:      Re: Temp II Sensor Release
Comments: To: JRodgers <jrodgers113@GMAIL.COM>
In-Reply-To:  <52C0E02E.20303@gmail.com>
Content-Type: text/plain; charset=us-ascii

Sorry, I overshot a bit.

Karl Wolz
Sent from my electronic umbilicus

> On Dec 29, 2013, at 7:53 PM, JRodgers <jrodgers113@GMAIL.COM> wrote:
>
> Thanks. This effort was just to separate the connector from the sensor -
> not remove the sensor itself.
>
> John
>
>
>> On 12/29/2013 8:26 PM, OlRivrRat wrote:
>>         JR
>>
>>     Assuming this pertains to your 88GL2.1L ~ You Push or SqueezeDown
>> (if you have it ConvenientlyOriented) on the WireClip & then if it
>> TheConnector does not want to come off easily you will probably need to
>> push a ScrewDriverBlade between TheConnector & TheSensor & then give the
>> ScrewDriver a GentleTwist ~ To remove the Sensor you Pull the
>> RetainingClip completely out & then Pull the Sensor out ~ Coolant
>> Will/Should Flow ~
>>
>>                                                     ORR ~ DeanB
>>
>>
>>> On 29 Dec , 2013, at 11:38 AM, JRodgers wrote:
>>>
>>> I need to release the Temp II sensor.
>>>
>>> Question: Does one push the release clip - or pull the release clip - to
>>> unlock and free the connector.
>>>
>>> Having a problem getting it loose and it's hard to see the action from
>>> on top.
>>>
>>> Getting underneath to look isn't an option for the time being. It's been
>>> raining and water is running under the van.
>>>
>>> Thanks,
>>>
>>> John
>>
>>