What's up with this?? I replaced the coil on Volksiebus with a brand new Bosch coil - VW spec'd. The tach worked right up to the point of change, when I disconnected the wires, installed the new coil, and reconnected the wires. Engine starts and runs fine - but for the tach - NO JOY! Anyone got any ideas. Everything appears as it should be. It's all wired back up exactly like the original coil - wires same places. But no tach. I haven't done this yet - but I can do a voltage test from the +15 pin to ground without blowing something up, can I not. Been a long time since I've had a meter out for anything but a continuity check. Suggestions appreciated. Thanks, John |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.