Date: Wed, 29 Jan 2014 16:33:02 -0600
Reply-To: Jim Felder <jim.felder@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jim Felder <jim.felder@GMAIL.COM>
Subject: Re: Question about rear seat operation/removal
In-Reply-To: <9a701.7a87a146.401ad8b7@aol.com>
Content-Type: text/plain; charset=ISO-8859-1
RE the latch rubber covers, I have never seen anything on a vanagon that
would work for these. I had never seen latches like this before. I think
all the diesels I have seen have been westies.
The rubber donuts that fit over the studs when the seat is down look to be
exactly the same because the studs are the same, but the catch part of the
mechanism is like 3mm stamped steel, it take a narrow, long cover over its
hard edge length.
I'd like to talk with you further bout getting a folding bed from you.
Maybe a list member is coming my way sometime? I picked up my middle seat
in Florida on a family vacation years back!
All this is contingent upon me getting the thing running reliably, of
course. Until then the seat is about the least of my worries.
Best,
Jim
On Wed, Jan 29, 2014 at 4:20 PM, <JordanVw@aol.com> wrote:
> the vinyl covered masonite kickpanel under the rear seat simply pulls
> straight off. there are 2 springloaded C clips that clip over the
> seatbottom tubing frame. grab ahold of the kickpanel and pull it straight
> off.
>
> then, you can access the bolts that hold the seatbottom.
>
> i dont think the rubber covers from a late model sofabed van will fot over
> those early style seatback release studs sticking out of the wall but you
> can try it.
>
> if it were me i would ditch that rear seat and install a sofabed from a
> later model vanagon. :) i actually have a brown corduroy rear sofabed
> cushion from a '85 vanagon that has no a/c pillar cutouts.. have tan
> velour as well.
>
>
>
>
> In a message dated 1/29/2014 4:48:31 P.M. Eastern Standard Time,
> jim.felder@GMAIL.COM writes:
>
> I'm trying to figure out how to get under the rear seat of "Fifty Shades Of
> Brown," my new-to-me 1982 diesel tintop.
>
> The rear seat back has a catch at each side that does, in a crude way, what
> the later center-lever release does on later models: it lets the seat come
> forward in an irritating almost-useful zombie position that is neither up
> nor down, pressing against the seat bottom and not going flat.
>
> However, the Owner Manual for the car says
>
> "The rear seat bench is secured with one bolt on each sidewall underneath
> the seat covering. Remove both bolts and take out the seat. The backrest
> portion of the bench should not be removed."
>
> Huh? What two bolts are they talking about and how do you get to them or
> even find them? You can tell it's too cold here to mess with this thing
> much. And why does it say nothing about the latches on the backrest?
>
> Does anyone know where I can get the rubber grips that go on the metal
> backrest latches? The bare metal looks like an accident waiting to happen.
>
> Jim
>
>
>
|