Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2014, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 9 Feb 2014 12:39:50 -0800
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: Exhaust Bushing Inner Weave Premature Failure
Comments: To: "SDF ( Scott Daniel Foss )" <scottdaniel@turbovans.com>
In-Reply-To:  <52F7DF8D.1010301@turbovans.com>
Content-Type: text/plain; charset=UTF-8

Good points. And that's interesting re bolted flanges. I always assumed they were there *only* to help with servicing the exhaust.

So with the TD, the obvious purpose aside (turbo boost), if I were to assume that the turbo dampens exhaust pulses, does this dampening reduce wear and tear on the exhaust system or just reduce exhaust noise?

Neil.

On 2/9/14, SDF ( Scott Daniel Foss ) <scottdaniel@turbovans.com> wrote:

> About the I4 diesel set up ... > for turbo diesel conversions mounted ala stock Diesel Vanagon ( which I > strongly recommend ..doing it the way VW did ..engine tilted to the left > at 50 degrees ) > all I have ever done is reproduce the stock DV system *exactly* .. > just in bigger pipes and with a glass pack, and I can't think of a case > where that did not last just 'forever' .. > and .. > one would think an inline 4 gas would have less vibration than an inline > 4 diesel. > > I've never even put a flex section in any exhaust system , just never > needed to.

> in my world, all pipe to muffler and pipe-to-cat junctions are bolted > flanges, per stock arrangement and never welded ...the junctions likely > allow expansion and slight movement, further reducing tendencies to crack. > > Readers may recall one of my engine conversion mottos .. > "Do what the manufacturers do." > > When they've been doing something the same way for decades ..you know it > works. > Why reinvent the wheel, aye ?

-- Neil n

Blog: tubaneil.blogspot.ca

'88 Westy http://tinyurl.com/c8rlw6p

'81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/

Vanagon VAG *Gas* inline-VR Engine Swap Group:

http://tinyurl.com/d7gd5ej


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.