Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2014, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 19 Feb 2014 21:37:51 -0800
Reply-To:     "Andrew R." <a.richar@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Andrew R." <a.richar@GMAIL.COM>
Subject:      Speedo cable install question
Content-Type: text/plain; charset=ISO-8859-1

Hey all,


I've got a new speedometer cable installed from the dash head unit down
through the body, bypassing the old OX counter box.  I've run into a
roadblock getting the other cable half out of the wheel assembly.  Trying
to pull it through the back side of the wheel assembly, I can't get it to
budge.


I've pulled the retaining clip off the cable at the grease cap, but I've
yet to pull the cap off.  Do I need to do this?  I replaced a cable on a
'72 Westy ages ago and it just slid through the hub w/o issue.  Not so with
this Vanagon.


thanks,
Andrew
87 GL 2WD
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.