Date:         Thu, 20 Feb 2014 13:46:40 -0800
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: Speedo cable install question
Comments: To: "Andrew R." <a.richar@gmail.com>
In-Reply-To:  <CAEqMk=OdgFR=Qzy6n+sSD3whJFwFzpZRWGrOmcoiwknDhhB1TQ@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8

No need to pull the grease cap.
A clamp holding lower portion of cable to frame needs to be loosened.
P 90.16 in my Bentley shows details.

I recall removing a cable from a junk yard diesel Vanagon. Cable was
quite stuck to grommet. Apply penetrating fluid to speedo cable where
it passes through grommet at steering knuckle.

Neil.

On 2/19/14, Andrew R. <a.richar@gmail.com> wrote:
> Hey all,
>
> I've got a new speedometer cable installed from the dash head unit down
> through the body, bypassing the old OX counter box.  I've run into a
> roadblock getting the other cable half out of the wheel assembly.  Trying
> to pull it through the back side of the wheel assembly, I can't get it to
> budge.
>
> I've pulled the retaining clip off the cable at the grease cap, but I've
> yet to pull the cap off.  Do I need to do this?  I replaced a cable on a
> '72 Westy ages ago and it just slid through the hub w/o issue.  Not so with
> this Vanagon.
>
> thanks,
> Andrew
> 87 GL 2WD
>


--
Neil n

Blog: tubaneil.blogspot.ca

'88 Westy http://tinyurl.com/c8rlw6p

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG *Gas* inline-VR Engine Swap Group:

http://tinyurl.com/d7gd5ej