At 08:53 PM 3/16/2014, JRodgers wrote: >Coolant level warning light has gone ape! It blinks for a few before >startin g - then on start it goes ape! Blinks 2-3 time/sec. Then it goes >solid red - no blinking at all - just red - the it goes out completely - >a few seconds later it's back to blinking again or solid red, or it >blinks but slows to one blink every three or 4 seconds. The LED inside the gauge has failed or the gauge supply voltage is off (10.0 +/- 0.5 V between skinny gauge ground pin and supply pin. It's 5-volt a self-blinking LED, so if it isn't blinking either the supply voltage is totally wack or it's broken. Yrs, d |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.