My familiarity with flat engines is mostly of the aircraft type, but there are similar considerations between them and the WBX and aircooled flat fours. The flat aircraft engines, the WBX and the aircooled VW engines are wonderfully made to be able to do a top overhaul fairly easy. First and always, one should do a crankshaft run-out check to determine wear condition of the crankshaft and main bearings. If good - or within limits - and oil pressure history is good - a top overhaul could/should be considered. Remove intake and exhaust, pull the heads, pull the jugs/cylinders and pistons and you are halfway there. New jugs/cylinders, pistons/rings and perhaps new rod piston pin bearings as necessary coupled with new/rebuilt heads will give you near new extended performance for a very long time. The WBX case and crankshaft are hell for stout and hold up well over time if not abused. It's been done many times. Just my $0.02! John On 4/14/2014 8:59 PM, Don Hanson wrote: > Jeff since you have the parts for an inline install, I'd say quit > messing with the WBX and just do the inline. If you use the 1.8 lite > motor with Digifant engine management you don't have to mess with much at > all...Everything is pretty much the same between those inlines and the WBX. > You can probably find one for about $200...and then you won't have these > ongoing issues with leaks and stuff. I got my van with a 92 rabbit/jetta > 1.8 liter motor and was happy with that ...probably the same HP as the WBX > motor and no leaky.... > After a couple of years when I found a good deal on an ABA. ($300 > complete) I kept the head and Digifant and bolted that onto the ABA 2.0 > liter block. Many say this hybrid motor is just as good as an ABA > complete...I don't know about that but it works great and it's dead-nuts > simple...I don't need the ABA OBD stuff, nor did I want to mess with > swapping all the electronics and building a bump to clear the manifold... > Took me about 3/4 of one day to swap that motor into my van rather than > the 1.8...It is more powerful than the 1.8... > > You said you thought you'd done everything just right and very carefully > and you still leak now..Why take the chance that that same scenario won't > replay next time? Get a Rabbit and stuff that in there with your already > in hand diesel parts.... > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.