Date: Tue, 6 May 2014 10:18:20 -0600
Reply-To: Gnarlodious <gnarlodious@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Gnarlodious <gnarlodious@GMAIL.COM>
Subject: Re: Fire Wall
In-Reply-To: <4171E4A7-C063-4447-BF7E-442BACAEA1C8@charter.net>
Content-Type: text/plain; charset=ISO-8859-1
OK, I'm not sure why you're so horrified at the polyurethane foam but
I'll take you seriously. I figure I need 34x66 inches replace the
sagging stuff, so I ordered 2 sheets:
http://www.supremesupplycompany.com/sound.htm
Tufcote Noise Barrier/Absorber #104-E
Size 32x36 per sheet @ $89 per sheet + UPS
Spoke with Ben
Will give a report when I get it installed.
-- Gnarlie
http://Gnarlodious.com/Vanagon
On Sat, May 3, 2014 at 11:43 AM, Michael <mbucchino@charter.net> wrote:
> Yes . NEVER use spray foam on any vehicle that you care about.
>
> Mike B.
>
> Sent from my iPhone
>
>> On May 3, 2014, at 13:37, Gnarlodious <gnarlodious@GMAIL.COM> wrote:
>>
>> I am getting ready to do that too, rip out all that dangling stuff and put modern stuff it. Because there is ample space under there I am hoping to put a thicker foamy insulating material, not necessarily spray-can stuff because its wasteful and expensive. Spray-on polyurethane foam may be the best solution, but I have only seen it applied with a wand from a running machine on a truck. The spray-on stuff is more dense and durable than the can-pressurized stuff, and normally applied to the ceiling of industrial buildings. The job needs to be done while the transaxle is out for best results, which means you order the truck go come and do it on location.
>>
>> Any thoughts?
>>
>> -- Gnarlie
>> http://Gnarlodious.com
>>
>>
>>> On May 3, 2014, at 10:57 AM, Neil N <musomuso@GMAIL.COM> wrote:
>>>
>>> And possibly reduce the amount of dust that falls into your face while
>>> wrenching under area above the transmission! ;)
>>>
>>> Dynamat et al would hold less dirt-dust?
>>>
>>> Neil.
>>>
>>>> On 5/3/14, Dennis Haynes <d23haynes57@hotmail.com> wrote:
>>>>
>>>> .... Any of them better than that factory mess. Shop online and
>>>> you will find more reasonable prices. Done right you can also reduce some
>>>> of the rust causing moisture issues.
>>>
>>>
>>> --
>>> Neil n
>>>
>>> Blog: tubaneil.blogspot.ca
>>>
>>> '88 Westy http://tinyurl.com/c8rlw6p
>>>
>>> '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/
>>>
>>> Vanagon VAG *Gas* inline-VR Engine Swap Group:
>>>
>>> http://tinyurl.com/d7gd5ej
|