Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2014, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 2 May 2014 09:46:44 -0700
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: An idea for Replacing Pop Top Canvas
Comments: To: J Stewart <fonman4277@COMCAST.NET>
In-Reply-To:  <724753304.1431648.1399045540813.JavaMail.root@sz0063a.westchester.pa.mail.comcast.net>
Content-Type: text/plain; charset=us-ascii

My hat's of to you doing it on the van. I found that even with gravity helping it was awkward to get the aluminum strips fastened and the canvas tight, especially in huge corners. I just can't imagine being on my back up there wrestling the strips to the fiberglass roof and getting the canvas positioned.

Alistair

> On May 2, 2014, at 8:45 AM, J Stewart <fonman4277@COMCAST.NET> wrote: > > And after having done two canvas replacements myself, one stapled and one later with the screws/rails, my vote is you DO NOT need to remove the top. I had no help, did both all by myself, but I can't see the need to remove the top. Jeff Stewart ----- Original Message ----- >> Hi, >> I've been thinking about how to replace my poptop canvas without >> having to actually remove the roof. Here's how I see it being done: >> 1. Raise the top. Unscrew the bottom edges of the canvas from the >> body. >> 2. Unbolt the rear hinges from the top. >> 3. Here's what I see as a departure from totally removing the top. >> Lift up the rear of the top 2 feet or so, so that the top actually >> pivots on the bars that hold up the front of the top. Place some sort >> of support under the rear of the top to hold it in place. >> 4. Unscrew canvas from the top. >> 5. But new canvas in place, screw it down. >> 6. Drop rear of top back down on its hinges, and bolt hinges to top. >> 7. Screw down the new canvas and it's brackets. >> Will this work? >> Ric >> 87 Westy >> Sent from my iPad


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.