Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2014, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 2 May 2014 09:46:07 -0700
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      LVC: Cutting Metal (sheet, plate, box, tube)
Content-Type: text/plain; charset=UTF-8

Hi all.

Finally signed a lease for a new Vanagon "shop" space. Reasonably sized: 21' x 18' x 8.x' high garage. I'm allowed to MIG weld, cut metal, but ventilation may be an issue. A cut-off wheel in angle grinder throws a lot of dust.

Do budget oriented metal shears generally last long enough for NON commercial use? eg: http://www.kmstools.com/magnum-12-hand-shear-3035 The thickest metal I work with so far, is 1/8" though I wonder if a shear like that would actually cut it. What about cutting 1.5" or 2" box steel?

I don't have an O2-acetylene set up.

Would a band saw suffice for cutting sheet, plate, box and tube material but not throw as much dust as a cut-off wheel? Other tool suggestions are welcome! I would not run a compressor.

I don't foresee a lot of fabrication. And since 110 VAC to garage is on a shared breaker, this may negate any real future fabrication work beyond cutting and tacking parts in place. Still. It would be fun to learn of things like intake manifold alterations, copying diesel vanagon carriers, etc.

Thanks much,

Neil.

-- Neil n

Blog: tubaneil.blogspot.ca

'88 Westy http://tinyurl.com/c8rlw6p

'81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/

Vanagon VAG *Gas* inline-VR Engine Swap Group:

http://tinyurl.com/d7gd5ej


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.