Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2014, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 May 2014 08:36:33 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: WBX Recommendations Sought
Comments: To: JRodgers <jrodgers113@GMAIL.COM>
In-Reply-To:  <538659E2.7000002@gmail.com>
Content-Type: text/plain; charset="US-ASCII"

I would have gotten the engine running and done a full evaluation before pulling the transmission. If both needed service pull them at the same time.

119K by itself does not indicate overhaul. Fun Bus is now over 270K and I drove it from NY to Florida last year and will likely be doing that again in a few weeks. Do the evaluation and take it from there. After all these years there are so many other things that can leave you on the side of the road and many of those failures will damage your fresh rebuild anyway.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of JRodgers Sent: Wednesday, May 28, 2014 5:49 PM To: vanagon@GERRY.VANAGON.COM Subject: WBX Recommendations Sought

A few years ago, I acquired a '91 carat that had sat in a garage for near 10 years. 3-1/2 years ago I got it running and it was sweet - BUT - I couldn't drive it because the tranny was toast. So it just sat. I would run it once in a while - the one day it just wouldn't start. I put it back in storage where it sat without running for three years until now. The tranny rebuild will be done soon BUT - after considering that the engine has 119,000 miles on it - and operated in who knows what kind of manner - and given that I plan a looooong trip cross country in it after it's put back on the road - I'm wondering if it wouldn't be prudent to just go ahead and have a complete top end overhaul from the get go. Heads, valves, cylinder barrels, rings, maybe even rod end bearings, oil pump and water pump. I know the lower end of these engines are tough, and I figure that the lower end would be just fine with a top overhaul.

Opinions and recommendations from our WBX Gurus are much solicited.

Thanks,

John Rodgers


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.