Jeff There is a LargeRubberGrommet where the FillerNeck fits into the MainBody of the Tank & they Get Old&Loose so when you fill the Tank AllTheWay ToTheTop of the FillerNeck you Loose all the Fluid that is above that Grommet ~ Makes a PrettyBigPuddle on the ground ~ So 1st just drop the Tank to check to see if it is really Empty or Full ~ MostProbably there won't even be a need to Unscrew the Ring that attaches the Neck to the Floor as they will (again, MostProbably) just separate & the Tank will drop ~ If it is the Grommet that is leaking & you are able to find a New1 let me know as I also need 1 ~ ORR ~ DeanB On 14 Jun , 2014, at 4:19 PM, Jeff Palmer wrote: > Hi list - windshield washer fluid pretty much runs through when adding. Haven't looked too closely yet - is it difficult to swap? > > Can't find them listed on any vendor site - any suggestions? For an 85. > > Thanks > Jeff |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.