You would have to rework the nose mount. Different nose mount bracket between the 2 types, different bolt patterns to the tranny and different length reach to the van crossmember. If you use the 091 nose mount bracket you will have to adjust for the different reach as it will be too short. As far as the shifter stuff, all you really need is the early rear shift rod and guide pin. Then adapt that to the later front shift rod, for correct length to reach the tranny. Mark Zeitgeist wrote: > I'm pretty sure I'll come to regret asking this, but I searched my Gmail > archives and on the Samba, and couldn't find an definitives regarding > whether this was physically possible. I know the shifter is quite a bit > different, but say if one had access to a complete AC van, could the trans > and shifter assembly be installed in a late model van? > > -- > Casey > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.