Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2014, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 8 Jul 2014 08:25:11 -0600
Reply-To:     OlRivrRat <OlRivrRat@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         OlRivrRat <OlRivrRat@COMCAST.NET>
Subject:      Re: Front wheel rattle
Comments: To: Stuart MacMillan <stuartmacm@GMAIL.COM>
In-Reply-To:  <016201cf9a37$5aa5ae40$0ff10ac0$@gmail.com>
Content-Type: text/plain; charset=us-ascii

When you attempt to be sure it is seated properly it is best to use a ScrewDriver

on the Lip Rather than Hammering on the Crown of the Cap so as not to Dent the Cap ~

ORR ~ DeanB On 7 Jul , 2014, at 5:01 PM, Stuart MacMillan wrote:

> That's your bearing cap. The other side has the speedo cable going through > a square hole with a circlip holding it. > > It should be a tight tap-in fit down to the shoulder formed on it. If it's > so loose it falls out after driving it in, lay it on pavement and rap it > with a hammer on the side or squeeze in a vice to make it slightly oval. > > No need to add grease, that's done when the bearings are packed at each > brake job, and very little should be in the cap. > > Stuart > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of > Eric Caron > Sent: Monday, July 07, 2014 3:38 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Front wheel rattle > > Hi folks, > > Off and on I've noticed a metal rattle sound coming from my > passenger side front wheel. today I pulled off the hub cap and found the > small cover that lives in the center over the large nut was off and only > held loosely in place by my old style metal bus hub cap. > > I pushed it back on but it pulls off again easily. What is supposed > to hold this small cap in place? on the driver's side the cap has a small > pin like thing coming out of the center. Not sure if this is holding it on > or if the drivers side is different for some reason. > > so, how can I secure this small cap? What is it called exactly? and though > there was some grease in there I wonder if that should be changed or > boosted. > > advice and recommendations are greatly appreciated. > > Eric Caron > 85 GL Auto


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.