My shielded wire from the O2 sensor to the ECU...that is badly aged and cracked, resulting in it shorting, again, from the signal wire inside to the metallic shielding. It's happened recently and again just yesterday.. .so I am wanting to replace the whole wire, all the way from the O2 sensor to the ECU.. Second question: Where might I source wire like that...and no, I don't want to replace my whole wiring harness...especially since I am running a hybrid inline power VW motor in my 84 Vanagon... I was planning on simply running another shielded wire across the engine compartment in parallel to the harness that carries the original wire (somewhere inside it) and there by solving my cracked and brittle wire shorting out problem... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.