Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2014, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 18 Sep 2014 21:36:33 -1000
Reply-To:     "SDF ( aka ;jim lahey' - Scott )" <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "SDF ( aka ;jim lahey' - Scott )" <scottdaniel@TURBOVANS.COM>
Organization: Cosmic Reminders
Subject:      Re: Air Bubble?
Comments: To: J Stewart <fonman4277@COMCAST.NET>
In-Reply-To:  <1462375688.18044583.1410697688839.JavaMail.root@comcast.net>
Content-Type: text/plain; charset=UTF-8; format=flowed

I could agree with the 'still more air in there theory' .. but more importantly .. ALWAYS have the heater valve open when filling and running a freshly installed engine or cylinder.

making sure coolant is flowing fully through the heater circuit with a freshly filled cooling system.. that's like 'fundamental' .. always always always make feeling good heat out of the front defroster vents part of your 'I'm getting this thing running for the first time , cooling system wise' procedure.

really . If someone did that ...didn't have the front heater working fully ( and rear too ) when filling a cooling system, that was working for me .. I just wouldn't know what to say. IMO it's as basic as air in tires.

lol..I'm still shaking my head. how could someone take a head off, fill the cooling system, and not have the heater working and fully checked out before heading out somewhere ..?????

live and learn ay !?

On 9/14/2014 2:28 AM, J Stewart wrote: > 1985 Westy, 1.9 with new right side cylinder head. Driving back from my apartment last night it was actually getting a bit chilly so I turned on the heat. When I did the cylinder head I replaced the water pump, thermostat, and temp sensors. Prior to that the van had always run cool and heater output was on the weak side. Now the temp needle sits just a little north of the LED, still touching the LED, but just a little high. Anyway, last night the heater output was very hot, but for about 10-15 seconds it turned cool then hot again. Does this mean I still have a bit of air in the cooling system? I'm thinking maybe yes. > > Jeff Stewart >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.