Date:         Mon, 6 Oct 2014 10:46:19 -0700
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: Vacuum hose slipping off fitting
In-Reply-To:  <1412610543.19624.YahooMailNeo@web185402.mail.gq1.yahoo.com>
Content-Type: text/plain; charset=UTF-8

And speaking of that small type of vacuum hose, on the 2.1 one of
these hoses runs to the rubber boot at the idle stabilization valve. A
crack at the small nipple where it meets the boot body could open up
at times, or not, depending on hose position? Regardless, it's a
potential source of a vacuum leak.

Repaired that part on my 2.1 just recently. Not sure how long repair
will last but I sleeved the small nipple with (fuel?) hose and covered
all with "Industrial" Gloop which is probably a knock off of "Goop"
but not "Gorp"   ;)

Of note, was intrigued to find a restrictor in that small nipple. Same
purpose as restrictor used on the 1.9 for the EVAP system?

Neil.

On 10/6/14, Richard Koerner <rjkinpb@sbcglobal.net> wrote:


> The problem has ALWAYS been that the vacuum hose (little one about 1/8" ID
> routing along the firewall) has slipped off of it's fitting (not slipped
> off, I inadvertently knocked it off while cleaning, etc.).  No vacuum, no
> advance.  Put it back on, and magically all is fixed.



--
Neil n

Blog: tubaneil.blogspot.ca

'88 Westy http://tinyurl.com/c8rlw6p

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG *Gas* inline-VR Engine Swap Group:

http://tinyurl.com/d7gd5ej