Date: Tue, 14 Oct 2014 18:44:23 -0400
Reply-To: Jimmy Johnston <inmytree1@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jimmy Johnston <inmytree1@GMAIL.COM>
Subject: Re: Lost power while driving, now no start
In-Reply-To: <543D9F0E.6020807@turbovans.com>
Content-Type: text/plain; charset=UTF-8
Thanks again all...here is an update:
I just pulled a trouble code 13 - Cam angle sensor. I see it's also called
"TDC Fault".
I'm hitting the google to figure out what that means...
Jimmy
Wilmington, NC
On Tue, Oct 14, 2014 at 6:09 PM, SDF ( aka ;jim lahey' - Scott ) <
scottdaniel@turbovans.com> wrote:
> Hi Jimmy...
> hope you get though your trials here.
>
> Vanagons of course do not have Check Engine Lights or use a VSS .
>
> what I do suggest as a very simple first step ..
> ( and it's totally silly not to have this simple too in your kit )
> is put a NOID light on an injector plug ..
> and crank engine and watch for the light to flash.
>
> if it's flashing brightly and regularily ...ecu is firing the injectors, a
> good sign.
>
> also ...it's Highly Useful to have a starter trigger wire hidden in the
> engine compartment..
> so you can crank the starter while back there by the engine. Highly,
> highly recommended for self-rescue, diagnostic reasons, and
> working-on-the-engine reasons.
>
>
> On 10/14/2014 2:55 AM, Jimmy Johnston wrote:
>
> Hello all,
>
> The engine in my 1991 GL with a 1992 2.2 (w/ manual trans) lost power while
> cruising at highway speed. No warning signs or ongoing issues that would
> indicate a problem. Basically, as I was driving along, the van's engine
> lost power (i.e., it felt like I took my foot of the gas and we slowed to a
> stop), the motor continued to run as I slowed. Pressing the gas pedal made
> no change as I guided it to the side to the road. I was in a bit of a
> panic as we were on our way to the airport to catch a flight, I don't
> recall if I turned the key to shut it down or if it just stopped. I did
> try to restart it, the engine turned and turned but did not start. It
> needed towed via AAA.
>
> I do hear the fuel pump when turning the key to the first position. I do
> have a check engine light (it did not come on prior or during the loss of
> power) to check for codes however I'm not sure how to pull codes on a
> non-running engine. I do have a VSS (the kind hooked up to the back of the
> instrument cluster). The ignition switch was replaced a year ago. I'm
> leaning toward a bad ECU. Thoughts and guidance would be very much
> appreciated.
>
>
> Jimmy
> Wilmington, NC
>
>
>
>
|