Well, I'm the curious sort and my innate desire for answers got the best of me. I had some thicker gasket material in my shop, so I traced out a new gasket, using a wood plug cutter to punch out the screw holes. Turns out an Audi t-belt idler pulley is the exact diameter of the inside cutout, so I razored around that. Preliminary results are promising, at least on the bench. Moves smoothly and silently up and down. I'll install and see how it behaves out there in the real world. On Mon, Nov 3, 2014 at 11:47 AM, Zeitgeist <gruengeist@gmail.com> wrote: > I'm futzing about with my PW regulator today, and found that after > cleaning and lubing the motor, the regulator was binding. I opened it up, > cleaned out the goop and rust, and then put it back together. It's binding > less, but still too much. On a whim, I slacked off the cover screws and > found that it freed all the way up again. Has anyone experimented with > installing a slightly thicker cover gasket to put less tension on the cable > reel? > > -- > Casey >
-- Casey |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.