Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (November 2014, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 11 Nov 2014 06:37:42 -0800
Reply-To:   Don Hanson <dhanson928@GMAIL.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Don Hanson <dhanson928@GMAIL.COM>
Subject:   Re: Oil pressure light
Comments:   To: Dennis Jowell <dennisjowell@gmail.com>
In-Reply-To:   <4E529D41-6049-424B-A8ED-56DFF0113B80@gmail.com>
Content-Type:   text/plain; charset=UTF-8

I think it is a good idea to also know your oil temperature, so I have an oil temp. gauge, too.. I find the coolant temperature gauge and blinking light for the coolant and the oil pressure warning system, as supplied in the Vanagon, leaves me guessing about the accuracy of the indications. Everyone here on the list has heard of issues with the Vanagon Oil and temperature gauge systems. Yes, these glitches can be fixed, avoided (most of the time) or eliminated..(again, most of the time) with just a small amount of care and attention to detail....but in say downtown LA or on an Atlanta freeway during rush hour, you don't need to be second guessing warning lights and buzzers... With a simple electric gauge to indicate oil temp, too, I have a confirming system to back up the sometimes false or erroneous readings we Vanagon people frequently see and hear from the factory supplied warning indicators. If your temp gauge reads 'cold' and the heater in front is blowing cool air yet you see a higher than normal Oil temperature, a condition often seen in Vanagons, you will know you have a problem.. After you've become familiar with the operating range that is normal for your particular motor and driving style you'll be able to confirm that when you hear a low oil pressure buzzer it is because you've maybe been 'hammering' into a big headwind at 85mph and now your Oil temperature has climbed into the 240F range and it is now thin from the heat..slowing up a bit might be better for your motor.... The electric oil temp gauges are single wire without moving parts and not much to error..a good inexpensive supplement to your stock equipment.

On Tue, Nov 11, 2014 at 3:31 AM, Dennis Jowell <dennisjowell@gmail.com> wrote:

> Stuart, > Great idea. I ordered a VDO with sender from bus depot. It's on its way. > If you,could send a photo of your install that would helpful. The gauge > should be here Thursday > > Dennis > > Dennis Jowell > Scotch Hollow Farm > > > > On Nov 10, 2014, at 4:30 PM, Stuart MacMillan <stuartmacm@gmail.com> > wrote: > > > > I have the VDO kit from Van Café: > > > http://www.van-cafe.com/home/van/page_362_263/oil-pressure-gauge-kit.html. > > It uses a T fitting so you can use the VDO sender and the stock sender > > together. I have this gauge and a voltage gauge mounted on top of the > dash. > > I can send a photo if you like. > > > > I think every Vanagon should have an oil pressure gauge. > > > > Stuart > > > > -----Original Message----- > > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf > Of > > Dennis Jowell > > Sent: Monday, November 10, 2014 11:23 AM > > To: vanagon@GERRY.VANAGON.COM > > Subject: Re: Oil pressure light > > > > Wiring looks ok now. I'll check again tomorrow when the sun comes out. > Where > > can I get a good oil pressure gauge for my van it on that is electrically > > operated. Not too familiar with brand names. Hopefully I can find a kit > that > > looks nice below the dash.Stewart Warner or VDO units? > > > > > > Dennis Jowell > > Scotch Hollow Farm > > > > > >> On Nov 10, 2014, at 12:07 PM, mark drillock <mdrillock@cox.net> wrote: > >> > >> The wire coming from the oil pressure switch by the pulleys should be a > > brown wire. It comes up and meets with another brown wire from the other > oil > > switch at a 2 pin connector by the thermostat housing. It is common for > > there to be a bad connection inside that 2 pin connector. Open it up and > > look closely. The other side of the 2 pin connector should have a yellow > > wire and a blue/black wire. The brown wire from the oil switch in > question > > MUST connect to the yellow wire. Sometimes the connector gets so damaged > > that someone cuts it out and splices the wires to each other. If that has > > happened then it is vital to make sure that the right wires got joined. > >> > >> Mark > >> > >> Dennis Jowell wrote: > >>> I checked the connection which seems ok. My thought that the harness is > > so,old and brittle that a short happened or does happen so often? Feeling > > the wire by hand the area that rides close to,the engine in more brittle > > than the rest of the harness. Although the insulation is intact > >>> > >>> Dennis Jowell > >>> Scotch Hollow Farm > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.