The wire coming from the oil pressure switch by the pulleys should be a brown wire. It comes up and meets with another brown wire from the other oil switch at a 2 pin connector by the thermostat housing. It is common for there to be a bad connection inside that 2 pin connector. Open it up and look closely. The other side of the 2 pin connector should have a yellow wire and a blue/black wire. The brown wire from the oil switch in question MUST connect to the yellow wire. Sometimes the connector gets so damaged that someone cuts it out and splices the wires to each other. If that has happened then it is vital to make sure that the right wires got joined. Mark Dennis Jowell wrote: > I checked the connection which seems ok. My thought that the harness is so,old and brittle that a short happened or does happen so often? Feeling the wire by hand the area that rides close to,the engine in more brittle than the rest of the harness. Although the insulation is intact > > Dennis Jowell > Scotch Hollow Farm > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.