Date: Mon, 24 Nov 2014 06:45:02 -0500
Reply-To: Dennis Jowell <dennisjowell@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Dennis Jowell <dennisjowell@GMAIL.COM>
Subject: Re: Oil pressure ?
In-Reply-To: <547188D3.6020604@cfu.net>
Content-Type: text/plain; charset=utf-8
Max,
I bought the VDO gauge and sender from Bus Depot. It all came together. Hopefully they put it together matching. Never checked it though.
Dennis Jowell
Scotch Hollow Farm
> On Nov 23, 2014, at 2:12 AM, Max Wellhouse <dimwittedmoose@CFU.NET> wrote:
>
>> On 11/22/2014 7:18 PM, Chris S. wrote:
>> 2 bar at 80 degrees centigrade at 2000 rpm with factory oil viscosity, which I believe is 30 weight, is the low minimum guide in Bentley.
>>
>> Which seal was replaced? Was it oil pump? May want to check clearance between oil pump gears and cover.
>>
>> Chris.
>>
>> Wysłane z iPhone'a
>>
>> Dnia Nov 22, 2014 o godz. 17:50 Dennis Jowell <dennisjowell@GMAIL.COM> napisał(a):
>>
>>> After installing my new VDO electric oil gauge I finally took my 88 Westy out this afternoon for a test ride. Driving the interstate at 65 mph, oil is at 22 psi, drove for another 40 miles down to the exit ramp and oil pressure light/buzzer goes off at the end of the ramp. PSI was at 6 at 900 rpm's. Is this common? Or is there a problem with my new GOWESTY engine that has 3000+ miles on it ?
>>>
>>> Dennis Jowell
>>> Scotch Hollow Farm
> One popinyt that hasn't been brought up is there a chance that the range
> for the sending unit doesn't match the VDO gauge. VDO offers both a
> 0-150 and a 0-70 gauge and I don't know if this would be an issue, but
> both the 0-150 and the 0-70 PSI VDO electric sending units look almost
> identical, except for the small nomenclature stamped on the body of the
> unit. Perhaps finding an old mechanical pressure gauge and hooking it up
> to the outlet might shed some light on the good gauge/bad gauge theory.
>
> My Boston Bob rebuild from 2000 or thereabouts has over 150k on it and
> still generates 60+PSI at start up with Mobil1 15/50 and even after
> extended heavy loads always has more than the list's "Golden Rule" of
> 10PSI/1000 RPM benchmark. If you do use a mechanical gauge(like an old
> Stewart Warner etc). I would test it on someone's engine with known
> good oil pressure to make sure it's working properly and maybe even use
> your system on that person's car to make sure it's healthy too. There's
> a lot at stake here for sure. I hope you find out the problem....and soon!!
>
> DM&FS
|