Brilliant! In this case I am adding it on the driver's side as my '90 Euro doka never came w/ one. Thanks! Mr. BZ-as a retired architect, I should have been able to figure this out!
On Wed, Nov 26, 2014 at 9:54 AM, Dan N <dn92610@gmail.com> wrote: > *"how do you line up the screw holes from the pocket on the back side of > the door panel?"* > > - tape a piece of paper on the pocket, draw around it, punch holes on the > screw holes then take the paper out and tape it on the door panel and drill > holes - You don't need to take out the whole door panel, just remove the > clips on the bottom and left side of the panel (facing it) > > or > > - take a piece of chalk, carve it till it's small enough to be inserted in > the screws holes - a piece of chalk for each screw hole. Position the > pocket with the chalk over the door panel and then you will have chalk mark > on it, it's where you will drill the holes. > > remember to give clearance for the glove box. >
-- Tom Buese |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.