Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2015, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 13 Jan 2015 06:25:34 -0600
Reply-To:   Tom Hargrave <thargrav@HIWAAY.NET>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Tom Hargrave <thargrav@HIWAAY.NET>
Subject:   Re: Source for reliable axle assemblies
Comments:   To: Dennis Jowell <dennisjowell@GMAIL.COM>
In-Reply-To:   <CC587FC2-D102-4B9D-AA84-8AF6D3FF37CD@gmail.com>
Content-Type:   text/plain; charset="us-ascii"

Yes, but in my opinion NAPA is one of the better chains.

Thanks, Tom Hargrave www.kegkits.com www.stir-plate.com www.towercooler.com www.grow-sun.com www.raspberryproject.com http://goo.gl/niRzVw

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] On Behalf Of Dennis Jowell Sent: Tuesday, January 13, 2015 5:14 AM To: vanagon@GERRY.VANAGON.COM Subject: Re: Source for reliable axle assemblies

Quick question is FLAPS like a NAPA store out here in New England?

Dennis Jowell Scotch Hollow Farm Newbury, Vermont

> On Jan 12, 2015, at 8:23 PM, Jim Felder <jim.felder@GMAIL.COM> wrote: > > I don't know what your situation is exactly, but if this applies to > it, you can go to a FLAPS and buy a needle injector that will snap > onto your grease gun. This will penetrate the rubber boot and apply grease to the CV joint. > Not perfect, massaging the boot will help. If simple lubrication is > your problem, this technique, if done right with say 15 strokes of the > gun, could help. If you have some other problem, it's won't help. > Sounds like you are getting to your early, though. > > Jim > >> On Mon, Jan 12, 2015 at 4:03 PM, John Seehorn <jseehorn@hotmail.com> wrote: >> >> Thanks for all of the suggestions. I did check for loose bolts and >> found a couple loose on the RH side outer. I'm positive they were >> tight at installation and tightening them did not make the noise go >> away. So I suspect that the RH axle is the one causing the noise. >> I'm going to try swapping the axles first. >>

----- No virus found in this message. Checked by AVG - www.avg.com Version: 2015.0.5645 / Virus Database: 4257/8895 - Release Date: 01/09/15


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.