Date:         Tue, 20 Jan 2015 19:22:06 -0800
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: Tool Suggestion? Re: Rear Trailing Arm Replacement Fun!
Comments: To: Neil N <musomuso@gmail.com>
In-Reply-To:  <CAB2Rwfhz806brfDQx+D3S3NoPKveL6mQXQO4SzV=Vw+kwB4yEg@mail.gmail.com>
Content-Type: text/plain; charset=us-ascii

Guard off the grinder?

If you have a compressor, then you can use a small air powered cut off tool. Like a mini grinder but smaller body.

Alistair



> On Jan 20, 2015, at 6:48 PM, Neil N <musomuso@gmail.com> wrote:
> 
> I'll double check but it appears my 4.5" grinder body will end up
> hitting the portion of mount bracket sitting below the bushing. That
> bracket being different than the outboard bracket.
> 
> I'm using a 4.5" grinder
> 
> I need a lift and more tools!     ;)
> 
>> On 1/20/15, Alistair Bell <albell@shaw.ca> wrote:
>> 
>> Neil,
>> 
>> Is it a case of the angle grinder body interfering with getting at the bolt
>> or the disk itself? I keep small used disks around for tight spots.
>> 
>> Alistair
>> 
>> 
>> 
> 
> 
> -- 
> Neil n
> 
> Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>
> 
> 1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>
> 
> 1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

> 
> Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>