Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2015, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 28 Feb 2015 14:45:55 -0800
Reply-To:     Stuart MacMillan <stuartmacm@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stuart MacMillan <stuartmacm@GMAIL.COM>
Subject:      Re: Rotor question
Comments: To: Michael <mikewelldon@ICLOUD.COM>
In-Reply-To:  <8D541309-6AE9-4A72-9D0C-4298B070847F@icloud.com>
Content-Type: text/plain; charset="us-ascii"


1/2 cm sounds right to me.  You may have left off the spacer on the spindle
that the oil seal rides on on the driver's side.


Stuart


-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Michael
Sent: Saturday, February 28, 2015 11:18 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Rotor question


I'm doing my rotors and bearings (first time). The driver side rotor went on
fine. The passenger side is different. I put the rotor on as far as it will
go and there is a gap about 1/2 cm between the rotor and the dust shield. No
gap on drivers side.


Any ideas before I beat it to death with a hammer?


Mike=
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.