Kevin, I would also replace the oil cooler o-ring if you haven't done that yet. You won't lose much oil either way. The sensor just a few tablespoons. The oil cooler o-ring, less than half a quart especially if you don't dump out the oil filter. Hope this helps. Ken Wilford John 3:16 www.vanagain.com On Thu, Mar 5, 2015 at 10:50 AM, Kevin Duvernay <kduvey@gmail.com> wrote: > I'm swapping out my motor mounts tomorrow. While I'm there I'm also going > to replace the #2/4 header. If that goes smoothly, I've also got a new > water pump along with all new coolant pipes/gaskets and hoses (its > basically the last bits of my complete cooling system overhaul!) > > Anyways, I figured while I'm there doing all this I minus well toss in a > new high pressure oil sender (the grey one, .9 bar). What I'm wondering is, > is it possible to do this without loosing too much oil? I JUST changed the > oil out to some really expensive Redline synthetic stuff, would hate to > waste any of it... > > Also, anything else I should address while I'm back there? > > Kevin >
-- Thanks, Ken Wilford John 3:16 www.vanagain.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.