Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2015, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 6 May 2015 12:31:22 -0400
Reply-To:     Edward Maglott <emaglott3@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Edward Maglott <emaglott3@GMAIL.COM>
Subject:      Re: Wonky temp gauge
In-Reply-To:  <00b701d08814$21f08a40$65d19ec0$@gmail.com>
Content-Type: text/plain; charset=UTF-8

I did a major overhaul on mine years ago and did this write up on it: http://staff.blueridge.edu/~edwardm/vanagon/pp023/index.htm

On Wed, May 6, 2015 at 11:48 AM, Stuart MacMillan <stuartmacm@gmail.com> wrote:

> These cluster bodies were made from poor quality plastic and are all > falling apart. Go Westy has hold down tabs for the broken off corners were > it attaches to the dash: > http://www.gowesty.com/ec_view_details.php?id=23954&category_id=&category_parent_id= > > The bosses where the speedo and tach/clock screw into the cluster also > break, and can be repaired with epoxy and re-drilled (same with the map > pocket on the driver's door). > > The biggest problem is with the speedo. People push too hard on the > mileage reset button and break the corners off the speedo. I've made a > rather inelegant fix by epoxying a long screw to the cluster below the > speedo that I can slip a fender washer and wing nut over to hold the bottom > down. Ugly, but it has worked for four years so far. I'm genuine wingnut > VW repairman. > > Now that GW has solved the foil problem, it's time for them to commission > new cluster bodies now! I'm sure they would be under $500, right? > > Stuart > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf > Of Jeff Palmer > Sent: Tuesday, May 05, 2015 10:55 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: Wonky temp gauge > > I think I’m beyond that. 30 years of +30 to -30C weather. Everywhere > there is a screw, it is crumbling. > > Jeff > > > On May 4, 2015, at 3:21 PM, David Beierl <dbeierl@attglobal.net> wrote: > > > > At 02:44 PM 5/2/2015, Jeff Palmer wrote: > >> The plastic cluster is barely holding itself together. > > > > I've heard very good reports of this stuff: http://www.rapid-fix.com/ > > > > d > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.