Date: Tue, 5 May 2015 11:23:35 -0500
Reply-To: John Rodgers <jrodgers113@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: John Rodgers <jrodgers113@GMAIL.COM>
Subject: Re: That oil buzzer
In-Reply-To: <CABFHYstR4sUjXoJAZLwPkLZ4Qf-rjNNvErst+kv8MnaS6g2-=g@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8
Had the same problem on my '88 GL. Dennis clued me in. Pulled out
sufficient oil to get it halfway between 5he marks. Now no more problem.
One other thing - every time I dropped from highway speed to idle, say at a
stop light, in my CARAT with the auto-tranny, the oil light would come on.
Nerve racking! Dennis clued me in there too. Raised the rpm by 50 and no
more problem. For some reason the WBX 2.1L engine when mounted to an
auto-tranny just needs that extra 50 rpm to keep oil pump pressure where it
needs to be.
John
On May 5, 2015 9:38 AM, "Kk Al" <kkalnsf@gmail.com> wrote:
> Thank you for this helpful reply. Based on this I removed the excess oil.
> So far the warning light and buzzer have not returned. Fingers crossed that
> was the culprit.
>
> On Monday, May 4, 2015, Dennis Haynes <d23haynes57@hotmail.com> wrote:
>
> > Part of your problem maybe that it is slightly over the "Full" mark. That
> > is not the "Full" mark. It should be labeled what it really is. It is
> > "Maximum" do not ever exceed no matter what mark. Seriously, the water
> > boxer can be very sensitive to oil level in addition to viscosity. When
> > overfilled the crank and cam will churn in it causing it to get hot and
> > possibly even aerated. Both will reduce oil pressure. In addition the
> > excess will get carried past the piston rings (pistons on their sides)
> and
> > get carried out where it can foul the o2 sensor and the catalytic
> > converter. This happens over time during extended high speed-load
> > operation. And what oil viscosity are you using?
> >
> > Check the archives for more information. Basically there are two oil
> > pressure switches. The higher pressure switch is looked at when the
> engine
> > is over 2,000 rpm. That will give the light and buzzer. Once on it will
> > stay on until the oil pressure becomes adequate or you cycle the ignition
> > switch. If you have the correct .8 bar sensor it is telling you that you
> > didn’t have 11-12 psi oil pressure over the 2,000 rpm.
> >
> > Dennis
> >
> >
> > -----Original Message-----
> > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com
> > <javascript:;>] On Behalf Of Kk Al
> > Sent: Monday, May 4, 2015 5:34 PM
> > To: vanagon@GERRY.VANAGON.COM <javascript:;>
> > Subject: That oil buzzer
> >
> > 87 Syncro here
> > We are on long weekend. It's a nice 76 degrees out. Van is running well,
> > temp is normal. Fresh oil and filter. When we pull off an exit the oil
> > buzzer goes off and warning light turn on. We stop, check the oil. It's
> > slightly over the full mark and clean.
> >
> > I thought I read somewhere that the oil light can come on due to high or
> > low pressure.
> >
> > Thoughts?
> >
>
|