|
Suggestions please: Fuel delivery problem. If I squirt some fuel into the intake downstream of the AFM the engine starts right up and runs until the fuel is gone. I did the fuel pump rate test as per Bentley and had near zip output. Went through the system from the tank nipple (blasted some air in there to blow out any blockage-fuel runs fine,), Replaced the fuel filter, disconnected both ends of the post pump to "T-pipe" connector and blew out the line. Checked flow again at the pressure regulator return outlet. No flow. Removed the input hose from the T connector and ran the pump again. Good fuel flow to the T pipe but none at the return pipe connector. Engine still does not run. What do I do next? 83.5 water boxer, Thanks Don |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.