Date:         Tue, 30 Jun 2015 15:23:11 -0700
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: Propane and refrigerator success
Comments: To: george jannini <georgejoann@gmail.com>
In-Reply-To:  <CA+So781-2=R-JS9e=ukxLBsb8vgw=98Z6LEOp9L=7Rtuv7zM_Q@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8

There should be a screw to hold the element
in place. Image of 182A 1 pc. elements: http://tinyurl.com/pvkoum6
The screw doesn't have to be super tight; the outer metal
of the heating element(s) is relatively thin. It may
be that there is a dimple at the element for screw to seat in.

On that note, i recall reading of someone
shimming the element so it would contact the tube as
much as possible. But then the
internet is full of "information". IIRC, I hammered
a piece of brass flat and shimmed the element at the screw side
of tube.
I doubt doing this helped improve cooling though.

Neil.

On 6/30/15, george jannini <georgejoann@gmail.com> wrote:

> I probably have checked the heating element for fitment, the 12 volt
> element was loose enough to slide up and down the tube it's in.


--
Neil n

Blog: Vanagons, Westfalia, general <http://tubaneil.blogspot.ca>

1988 Westy Images <https://picasaweb.google.com/musomuso/New1988Westy>

1981 Westfalia "Jaco" Images, technical <http://tubaneil.googlepages.com/>

Vanagon-Bus VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>